How to run Advanced network test
Would you please check my test sample and let me know if it meets the correct test scenario in Advanced network test?
Test scenario 1:
I set 4 systems on the same network, I run BurnIn on one of them, the other three system running "end point".
Test scenario 2:
I set 4 systems on the same network, I run BurnIn on three of them, the last one system running "end point".
Only Test scenario 1 is valid. Only one instance of BurnInTest can run the advanced network test at the same time.
I'm new to burn-in test
I am trying to use advanced network test in Scenario 1 above.
However I only see an Active Network on 1 off 5 PCs with endpoint running. I was expecting Burn-in to create a connection to all 5. Have I misunderstood this?
Thanks for your help.
How many network cards do you have in the machine under test (MUT)?
How are the end points connected to the MUT? e.g. just a switch, or maybe routers, or maybe across the internet?
Hi David, thanks for your reply.
It is just a single network card in the MUT. The 4 PCs are all on a LAN through a managed switch.
If you only have a single network card, then it will only connect to 1 end point at a time.