View Full Version : Encase Mounting Error OSFMount
01-03-2012, 04:42 PM
I'm trying to mount a EnCase image size is about 110GB and is spread in files E01 to ECV (173 split files, ~650MB)
When I try to open with OSFMount is reports the E01 file as "Raw Image" and does not mount a valid disk.
I suspect this could be a 32-bit Windows problem? Does anyone know if this problem would go away with a 64-bit host?
Has OSFmount been tested with an image this large?
01-03-2012, 06:10 PM
Thanks for the info. It may be because of the large number of split files. We'll test it out on our side and keep you updated.
01-03-2012, 08:25 PM
I installed a 64-bit client to try it out. I had more luck but not total success:
Disk Size reported incorrectly inside OSFMount as 698.9GB for two different images of different sizes (so I suspect a bug)
Disk Image is correctly identified as "EnCase" format this time (was not in 32-bit mode)
Disk mount is unrecognized file system in Windows Shell - I guess the incorrect disk size of 698.9GB is effecting the mounting of the file system?
01-03-2012, 08:32 PM
We are thinking there might be a bug that we only support file names with numerical splits.
E01 - E99.
We will let you know.
01-03-2012, 08:36 PM
Looks like EnCase goes like this once it hits .E99:
EAA, EAB, EAC, EAD, EAE, EAF....
Hope this helps (and thanks for your fast replies)
01-05-2012, 04:27 PM
John, I've sent you a private message regarding gathering some more debug info.
Powered by vBulletin® Version 4.1.12 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.